KEB COMBIVERT F6 Programming Manual

Motor parameterization
© 2022 KEB Automation KG
269
dr02
motordata state
Bit
Function
Value
Plaintext
Function
0-1
motor-
data
state
0
fill motor-
data
New data are written, but not transferred yet
1
storing
motordata
Initialization of standardizations
2
motordata
stored
The data are transferred for the control, but the storage in the
EEPROM is not completed yet
3
error norm
motordata
Error occurred in standardization routine:
• Control parameters could not be calculated (motor / in-
verter size not suitable, motor data not associated)
• Rated switching frequency too low
It can be selected between asynchronous and synchronous motor via dr00 motor
type.
dr00
motor type
Value
Name
Note
0
asynchron. motor (ASM)
an asynchronous motor should be parameterized
1
synchronous motor (SM)
an asynchronous motor should be parameterized
4
synchronous reluctance motor
(SynRM)
The start-up of this motor type is currently only possible in
cooperation with KEB.
Information can be obtained from the sales representative
responsible for you.
The equivalent circuit data (resistance, inductance) must be preset as phase-
phase values.
If only phase values are specified in the data sheet these values must be con-
verted in phase-phase values (depending on the circuit mode) for inverter parame-
ters.
Switching type
Inverter value
Star ( Y )
Phase value * 2
Delta ( Δ )
Phase value * 2/3
The dr parameters differ in nameplate data, equivalent circuit data (determined of
data sheet or auto-ID) and application-specific data.

KEB COMBIVERT F6 Specifications

General

Brand	KEB
Model	COMBIVERT F6
Category	Controller
Language	English