Function Guide (Transceiver Status):
Whether to execute voice guidance can be configured for each of the following transceiver statuses:
Table 6-31 Function Guide (Transceiver Status)
Configuration Description
Radio Locked The transceiver was operated when in Transceiver Password Mode.
Status Message Denied The target party did not receive the data or message.
Table 6-32 Configuration for Function Guide (Transceiver Status)
Configuration Description
None Voice guidance is not executed.
Audio file
The transceiver status is notified by using the audio configured by a user.
Configure the audio to be used by selecting from the audio files registered in Audio
Library.
Configuration using KPG-D1/ D1N
0
Configuring Function Guide to be enabled or disabled ( Transceiver Settings > Optional Features > Optional
Features 1 > Voice Announcement > Function Guide)
0
Configuring
voice guidance when the PF key is operated (On/ Off) (
Transceiver Settings > Optional Features >
Optional Features 1 > Voice Announcement > Function Guide)
0
Configuring voice guidance to notify the transceiver status (Radio Locked/ Status Message Denied) (
Transceiver Settings > Optional Features > Optional Features 1 > Voice Announcement > Function Guide)
Status Guide
Status Guide is the function to notify the received status by using the audio configured by a user.
To use this function, “User Programmable” needs to be configured in Voice Announcement Type.
(Refer to Configuring Voice Guidance Method (Voice Announcement Type).)
Whether to execute voice guidance can be configured for each of the statuses registered in the Status List.
Also, whether to execute voice guidance can be configured when various Emergency Statuses (Emergency Status/ Man-
Down Status/ Lone Worker Status/ Stationary Status/ Motion Status) are received.
Table 6-33 Voice Announcement (Status/ Emergency Status Response)
Configuration Description
None Voice guidance is not executed.
Audio file
Contents such as a status name are notified by using the audio configured by a user.
Configure the audio to be used by selecting from the audio files registered in Audio
Library.
If the transceiver receives a status, voice guidance is executed after an Alert Tone sounds from the transceiver. The number
of times executing voice guidance corresponds to the configuration in Cycle of Special Alert Tone. However, if the Alert
Tone is configured not to sound, the Alert Tone does not sound from the transceiver, and voice guidance is executed only
once. (Refer to Configuring the Alert Tone (Alert Tone Pattern).)
6 SOUND
6.8 Using Voice Guidance (Voice Announcement)
Common FUNC (K, F)/Ver 2.20 142
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
