The transceiver is equipped with an internal clock IC. Using the internal clock IC, the current time can be displayed on the
display.
14.1
Displaying the Current Time
Pressing the Clock
key displays the current time on the display.
The current time also appears when “Clock” is selected after entering Menu Mode by pressing the Menu key. (Refer to
Using Menu Mode.)
Operating the transceiver
1
Press the Clock key.
The current time appears.
0
12H Display
0
24H Display
Menu Zone
+
Zone 1
Channel 1
12 : 34
A
M
Menu Zone
+
Zone 1
Channel 1
12 : 34
Note
0
If Clock Display is enabled, the current time appears on the display when the transceiver is turned ON.
0
The
transceiver is equipped with a separate battery for the clock IC. If the second rechargeable battery runs out, the clock
will not be displayed properly. Recharge the battery and then configure the clock again. In this case, “- - : - -” appears.
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF
keys on the transceiver (
Transceiver Settings > Key Assignment)
0
Configuring Clock Display
(
Transceiver Settings > Optional Features > Optional Features 1 > Display)
14 ADJUSTING THE TIME ON THE TRANSCEIVER
14
ADJUSTING THE TIME ON THE TRANSCEIVER
Common FUNC (K, F)/Ver 2.20 237
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
