15.3
Copying the Configuration Data to Another Transceiver (Clone
Mode)
Clone Mode can be used to copy the data configured for the transceiver to another transceiver.
Operating the transceiver
1
Turn the transceiver ON while pressing and holding the Function ([
]) key.
The transceiver enters Clone Mode.
Note
0
Refer
to the service manual for instructions on how to operate the transceiver in Clone Mode, and for details on the Clone
function.
0
To end Clone Mode, the transceiver must be turned OFF.
0
The following data cannot be copied in Clone Mode:
0
Tuning Data
0
Embedded Message with Password
0
KENWOOD ESN Data
0
P25 ESN Data
0
NXDN ESN Data
0
If the data is copied to a transceiver having a different firmware version number, this may result in an error or a failure of
the transceiver to function correctly. In such a case, the cloned transceiver operation must be verified prior to using this
transceiver on a regular basis.
0
Clone Mode does not function in a Multi RF Deck system for Mobile.
Configuration using KPG-D1/ D1N
Configuring whether to permit the use of Clone Mode (
Transceiver Settings > Optional Features > Optional Features
1 > Mode)
15 MODE
15.3 Copying the Configuration Data to Another Transceiver (Clone Mode)
Common FUNC (K, F)/Ver 2.20 242
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
