Note
0
Refer to the service manual for instructions on how to operate the transceiver in Front Panel Programming Mode.
0
To exit Front Panel Programming Mode, press the Home ([T]) key, and then press the Menu ([Q]) or [*] key on the
confirmation screen. The transceiver exits Front Panel Programming Mode and then restarts in User Mode.
Configuration using KPG-D1/ D1N
0
Configuring
whether to permit the use of Front Panel Programming Mode (
Model > Product Information > Feature
Selection)
0
Configuring Clone/Front Panel Programming Password (
Transceiver Settings > Optional Features > Optional
Features 1 > Password)
15.5
Overwriting the Firmware (Firmware Programming Mode)
Firmware Programming Mode can be used to write the firmware to the transceiver.
Operating the transceiver
1
Turn the transceiver ON while pressing and holding the AUX
key.
The transceiver enters Firmware Programming Mode.
Note
0
Refer to the service manual for instructions on how to operate the transceiver in Firmware Programming Mode, and on
how to write the firmware to the transceiver.
0
To end Firmware Programming Mode, the transceiver must be turned OFF.
0
If no firmware is written to the transceiver, the transceiver enters Firmware Programming Mode when the transceiver is
turned ON.
Configuration using KPG-D1/ D1N
Configuring whether to permit the use of Firmware Programming Mode (
Transceiver
Settings > Optional Features
> Optional Features 1 > Mode)
15 MODE
15.4 Changing the Configuration of the Transceiver (Front Panel Programming Mode)
Common FUNC (K, F)/Ver 2.20 244
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
