When the transceiver is turned ON after the power source is attached to the transceiver, the transceiver starts up. To make
the
transceiver ready for use, the configuration data needs to be created using KPG-D1/ D1N and written to the transceiver.
Figure 2-1 KPG-D1/ D1N Main Window
By using KPG-D1/ D1N, the zone and channel data needs to be configured and then the parameters for various functions
can be configured. Refer to the help texts for configuration methods.
2 GETTING STARTED
2
GETTING STARTED
Common FUNC (K, F)/Ver 2.20 20
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
