VOICE
Page 5
• ATTACK: controls the attack time of the ADR amplitude envelope for the layer. Lower
values means faster attack, higher values means slower attack. Values range from 0 to 127.
Default value is 64.
• DECAY: controls the decay time of the ADR amplitude envelope for the layer. Lower values
means faster decay, higher values means slower decay. Values range from 0 to 127. Default
value is 64.
• RELEASE: controls the release time of the ADR amplitude envelope for the layer. Lower
values means faster release, higher values means slower release. Values range from 0 to 127.
Default value is 64.
• RESO: controls the resonance of the filter for the layer. Values range from 0 to 127. Default
value is 64.
• CUTOFF: controls the cutoff frequency of the filter for the layer. Lower values mean a more
filtered sound, higher values mean a less filtered sound. Values range from 0 to 127. Default
value is 64.
• OFFSET: add a velocity offset to Note On MIDI messages. Values below 64 add a negative
offset, values above 64 add a positive offset. Values range from 0 to 127. Default value is
64.
• V-TONE (Vari-TONE): adds dynamics to the sounds. Changes the sample played for
consecutive Note On events for the same note. This creates some variation and produces a
more natural sound.
82 - KETRON - LOUNGE
To Next Page
Loading...