414 8163A/B, 8164A/B, 8166A/B User’s Guide
14 Error Messages
error message E10060: Laser <a> control failed (b, c, d, e)
description Checks the laser current source
test value a laser number
b measured current at low per and normal current source setting
c measured current at low power and high current source setting
d measured current at high power and normal current source setting
e measured current at high power and high current source setting
action Please return the unit to your local service center for repair
error message E10080: Laser <a> control for safety test failed
description To test the current safety comparator the laser current needs to be set to two different
values
test value a laser number
action Please return the unit to your local service center for repair
error message E10081: Safety comparator <a> test failed (b, c)
description Checks whether laser current safety comparator includes at the right conditions a
safety interrupt at the CPU
test value a laser number
b shows whether the interrupt flag was raised when the current was lower
than the limit
c shows whether the interrupt flag was raised when the current was higher
than the limit
action Please return the unit to your local service center for repair
To Next Page
Loading...
Need help?
General
