Keysight Technologies 8163A User Manual

8163A/B, 8164A/B, 8166A/B User’s Guide 389
Error Messages 14
Selftests
These tests are started after initialization of the instrument. This test
measures defined parameters, and tests them to limits.
error message Initialization Error - module temperature too high
(please wait a little bit and try again)!
description Module temperature is too high
error value (no error value)
action Doublecheck whether the fan is working and not blocked. Wait some time and reboot the
instrument. If the failure persists, please return the unit to your local service center for repair.
error message Main Peltier Temp. Selftest Failed (error value)
description Verifies whether the peltier temperature of the laser diode is within a given range
error value 13010 Peltier temperature is not in target range
action Please return the unit to your local service center for repair
error message Main Thermo Temp. Selftest Failed (error value)
description Verifies whether the temperature of the thermopositioner is within a given range
error value 13020 Thermopositioner is not in target temperature range
action Please return the unit to your local service center for repair
error message Main Peltier Curr. Selftest Failed (error value)
description Checks if peltier current for the laser diode peltier is below maximum
error value 13050 Laser peltier current is above maximum value
action Please return the unit to your local service center for repair

Keysight Technologies 8163A Specifications

General

Brand	Keysight Technologies
Model	8163A
Category	Multimeter
Language	English