160 Keysight EXG and MXG X-Series Signal Generators User’s Guide
Basic Digital Operation for N5172B/82B with Options 653/655/656/657
Waveform Sequence Softkeys
3. Name and store the waveform sequence to the Seq file catalog:
a. Press More > Name and Store.
b. Enter a file name and press Enter.
See also, “Viewing the Contents of a Waveform Sequence” on page 160 and “Setting Marker
Points in a Waveform Segment” on page 176.
Viewing the Contents of a Waveform Sequence
There are two ways to view the contents of a waveform sequence:
View the contents through the Waveform Sequences softkey
1. Press Mode > Dual ARB > More > Waveform Sequences.
2. Highlight the desired sequence.
3. Press Show Waveform Sequence Contents.
View the contents using the Select Waveform softkey
1. Press Mode > Dual ARB > Select Waveform.
2. In the Sequence On column, highlight the desired waveform sequence.
3. Press Show Waveform Sequence Contents.
Editing a Waveform Sequence
When editing a waveform sequence, you can:
— change the number of times each segment or nested sequence plays
— delete segments or nested sequences from the sequence
— add segments or nested sequences to the sequence
— toggle markers on and off (described on page 181)
— save changes either to the current waveform sequence or as a new sequence
If you exit the sequence editing menu before saving changes, the changes are lost.
Sequences save to the Seq file catalog.
Use the following steps to edit a sequence that has two different segments so that the first
segment repeats 100 times and the second segment repeats 200 times, then save the changes.
If you edit and resave a segment used in a sequence, the sequence does
not automatically update the RMS value in its header. You must select and
update the sequence header information (page 163).
To Next Page
Loading...
Need help?
General
