444 Keysight EXG and MXG X-Series Signal Generators User’s Guide
Using the N5102A Digital Signal Interface Module for N5172B/82B with Option 003/004 and
653/655/656/657
Operating the N5102A Module in Input Mode
Operating the N5102A Module in Input Mode
This section shows how to set the parameters for the N5102A module using the signal generator UI
in the input direction. Each procedure contains a figure that shows the softkey menu structure for
the interface module function being performed.
Refer to “Connecting the Clock Source and the Device Under Test” on page 431 and configure the
test setup.
Accessing the N5102A Module User Interface
Figure 17-16 shows the Auxiliary menu that is accessed by pressing the Aux Fctn key on the front
panel of the signal generator.
Figure 17-16 First-Level Softkey Menu
All parameters for the N5102A module are set with softkeys on the signal generator.
Press N5102A Interface to access the UI (first-level softkey menu shown in Figure 17-17) that is
used to configure the digital signal interface module. Notice the graphic in the signal generator
display, showing a setup where the N5102A module is generating its own internal clock signal. This
graphic changes to reflect the current clock source selection.
Figure 17-17 N5102A Interface Menu
Select either PXB or N5102A
connectivity.
The default selection is N5102A.
Aux Fctn
Press here to access the N5102A
menu.
Internal clock going to the DUT
Line is grayed out until the N5102A module interface is turned on
To Next Page
Loading...
Need help?
General
