Keysight EXG and MXG X-Series Signal Generators User’s Guide 3
Models, Options, and Front/Rear Panels for All Models
N5171B/N5181B RF Analog Signal Generators, Options and Features
N5171B/N5181B RF Analog Signal Generators,
Options and Features
*Items marked with an asterisk designate that a feature is only available for the model listed.
This section describes the options and features available
for Keysight N5171B/N5181B RF Analog signal generators.
For additional details on hardware, firmware, software, and documentation, refer to the Data Sheet;
Data Sheets are also available from the Keysight Technologies website at
http://www.keysight.com/find/X-Series_SG.
Analog Modulation
— N5171B/81B-UNT AM, FM, Phase Modulation
— AM features: Log mode up to 40 dB; Linear mode 100% maximum depth
— FM features: DC to 7 MHz modulation rates; 16 MHz maximum deviation
— Simultaneously enable multiple modulation sources
— N5171B/81B-UNW Narrow Pulse Modulation
— Variable pulse widths, 20 ns minimum
— Variable repetition rate up to 5 MHz
— 10 ns rise and fall time
— 80 dB on/off ratio
— N5171B/81B-320 Pulse Train Generator
— Requires N5171B/81B-UNW Narrow Pulse Modulation
— Create a pulse sequence with up to 2047 independent pulses
— Individually vary pulse width and spacing
— Trigger the pulse train with a single event trigger
— Define pulse train from front panel GUI or a PC spreadsheet
— Import pulse train patterns
— Full SCPI commands
— N5171B/81B-303 Multifunction Generator
— Function generation
— Dual function generation
— Swept function generation
—Noise generation
To Next Page