Keysight EXG and MXG X-Series Signal Generators User’s Guide 315
Using Multitone and Two-Tone Waveforms for N5172B/82B with Option 430 and 653/655/656/657
Using Multitone Softkeys
Recalling a Multitone Waveform
Using this procedure, you learn how to recall a multitone waveform from the signal generator’s
memory catalog.
If you have not created and stored a multitone waveform, complete the steps in the previous
sections, Creating a Custom Multitone Waveform on page 311 and Storing a Multitone
Waveform on page 314, then preset the signal generator to clear the stored multitone waveform
from volatile ARB memory.
1. Press Mode > Multitone.
2. Press Load/Store.
3. Highlight the desired file (for example, 5TONE).
4. Press Load From Selected File > Confirm Load From File.
5. Press Multitone Off On until On is highlighted.
The firmware generates the multitone waveform in ARB memory. After waveform generation, the
multitone waveform is available to be modulated on the RF output.
For instruction on configuring the RF output, see Configuring the RF Output on page 313.
To Next Page
Loading...
Need help?
General
