Keysight EXG and MXG X-Series Signal Generators User’s Guide 389
Using Avionics VOR/ILS Softkeys for N5171B/72B and N5181B/82B with Option 302
Using ILS Glide Slope Softkeys
b. (Optional) Select a <value> from 0 to 99% and press Enter.
9. Set the ILS Glide Slope mode.
a. Press ILS GS Mode
(Default selection is OFF.)
b. Select NORM to turn on both the Up (90 Hz) and Down (150 Hz)
ILS Glide Slope signals.
10.Set the modulation to on.
a. Press MOD On and verify that the front panel LED is illuminated,
indicating that it is on.
(Default is on).
11.Set a desired RF power level.
a. Press Amptd
(Default power level is around -144 dBm, and depends on the signal
generator model being used, so the signal may be very low and hard
to find if you do not specify a high enough power level.)
b. Select a <value> from -20 dBm to -40 dBm.
12.Set the RF output to on.
a. Press RF On and verify that the front panel LED is illuminated,
indicating that it is on.
(Default is off).
13.Verify that all settings are as expected on the signal generator display.
a. Press Aux Fctn > Avionics > ILS Glide Slope
b. Review the settings under
ILS-GS Status Information
To Next Page
Loading...
Need help?
General
