Keysight B2980B User’s Guide, Edition 1 183
Front Panel Reference
Trigger Key Group
Trigger Configuration Dialog Box
This dialog box is used to set the trigger parameters in detail. Note that the
overlapped parameter values are ignored and replaced with the settings made on
the Meter view. See “Trigger Setup Sub-panel” on page 157.
Layer Specifies the layer or device action set by this dialog box.
ARM: Arm layer
TRIGGER: Trigger layer
ACTION: Device action
For ACTION, the available parameters are Layer, Action, and
Trigger Output.
Action Specifies the device action type set by this dialog box.
TRANS.: (B2985B/B2987B) Transient (voltage source output)
device action
ACQ.: Acquire (measurement) device action
Count Count, 1 to 100000 or INF. (infinity), for the action specified by
the Layer and Action parameters
Bypass Bypass, ON or OFF
Bypass = ON enables the bypass only for the first passage to
the event detector for the action specified by the Layer and
Action parameters.
Bypass = OFF disables the bypass.
Trigger Source Event for the action specified by the Layer and Action
parameters. AUTO, BUS, TIMER, INT1, INT2, LAN, EXT1, EXT2,
EXT3, EXT4, EXT5, EXT6, EXT7, or TIN (Trigger In connector).
See Table 4-9.
For using the Trigger In connector, it is necessary to set input
trigger polarity. See “BNC Configuration Dialog Box” on
page 195.
Period Only for the TIMER event.
Interval of the TIMER event for the action specified by the Layer
and Action parameters, 10 s to 100000 s
To Next Page
Loading...
Need help?
General
