Kikusui TOS3200 - Page 13

TOS3200 13
Troubleshooting
See “Troubleshooting” on page 205.
• How do I save the test results?
→
“Storing the Test Results”
67
• How do I save the present test condi-
tions and use them later?
→
“Panel Memory”
38
• How do I measure the voltage between
measurement terminals A and B?
→
“Displaying the Voltage between the
Measurement Network Reference
Points”
64
→
“Measuring in Meter Mode”
72
• How do I prevent the test conditions
from being changed inadvertently?
→
“Key Lock”
36
• How do I perform consecutive tests by
changing the test conditions for each
test?
→
“Program Tests”
76
• How do I apply an external signal to con-
trol the TOS3200?
→
“SIGNAL I/O Connector”
96
• How do I record the start and end of the
test on the printer?
→
“Talk mode”
106
Operation
• How do I check whether the test leads
are conducting signals correctly?
→
“Measurement Check”
162
• How do I change the calibration due
date?
→
“Time Settings and Calibration Manage-
ment”
164
• How do I synchronize the system clock?
→
“Time Settings and Calibration Manage-
ment”
164
• How do I replace the fuse?
→
“Replacing the Fuse”
166
Maintenance