TOS3200
25
2
Installation and Preparation
Precautions Concerning Installation Location
Be sure to observe the following precautions when installing the product.
● Do not use the product in a flammable atmosphere.
To prevent explosion or fire, do not use the product near alcohol, thinner or other combus-
tible materials, or in an atmosphere containing such vapors.
● Avoid locations where the product is exposed to high temperature or direct sun-
light.
Do not install the product near a heater or in areas subject to drastic temperature
changes.
Operating temperature range: 0 °C to +40 °C (+32 °F to +104 °F)
Storage temperature range: -20 °C to +70 °C (-4 °F to +158 °F)
● Avoid humid environments.
Do not install the product in high-humidity locations near a boiler, humidifier, or water sup-
ply.
Operating humidity range: 20 %rh to 80 %rh (no condensation)
Storage humidity range: 0 to 90 %rh (no condensation)
Condensation may occur even within the operating humidity range. If this happens, do not
use the product until the condensation dries up completely.
● Be sure to use the product indoors.
This product is designed for safe indoor use.
● Do not install the product in a corrosive atmosphere.
Do not install the product in a corrosive atmosphere or in environments containing sulfuric
acid mist, etc. This may cause corrosion of various conductors and bad contacts of con-
nectors inside the product leading to malfunction and failure, or in the worst case, a fire.
● Do not install the product in a dusty location.
Accumulation of dust may lead to electric shock or fire.
● Do not use the product where ventilation is poor.
Secure adequate space around the product so that air can circulate around it.
● Do not place objects on the product.
Placing heavy objects on top of the product may cause failures.
● Do not install the product on an inclined surface or location subject to vibrations.
The product may fall or tip over causing damages and injuries.
● Do not use the product in a location where strong magnetic or electric fields are
nearby or a location where large amount of distortion and noise is present on the
input power supply waveform.
The product may malfunction.
To Next Page
Loading...
