• What accessories are included?
→
“Checking the Package Contents”
24
• The EUT power cord cannot be con-
nected to the front panel outlet. What is
the workaround?
→
“Using the Terminal Block on the Rear
Panel”
42
• How do I check the operation of the EUT
before testing?
→
“Checking the EUT Operation”
44
• How do I measure the TC (when touch-
ing with my palm)?
→
“Using the Flat Probe (FP01-TOS)”
48
• How do I use the two test leads?
→
“Connecting the Test lead (TL21-TOS)”
45
• How do I check that correct measure-
ments can be made during the prelimi-
nary inspection?
→
“Measurement Check”
162
• How do I measure the TC?
→
“Setting Test Conditions of the TC Mea-
surement”
52
• How do I measure the PCC?
→
“Setting Test Conditions of the PCC Mea-
surement”
56
• How do I measure the TC using the exter-
nal circuit for that I was using until now?
→
“Meter Mode Measurement”
69
• How are the measured values are
judged?
→
“Judgment System”
50
• How do I stop measurements while the
EUT is starting up?
→
“Test Wait Time and Judgment”
51
• What is the maximum value during the
measurement?
→
“Maximum Value Hold Function of the
Measured Current (MEAS MODE)”
60
• What is the measured value at the volt-
age that is higher (or lower) than the
actual power voltage supplied to the EUT.
→
“Measured Current Conversion Display
(CONV)”
61
• How do I find when the TOS3200 was
calibrated the last time?
→
“Time Settings and Calibration Manage-
ment”
164
To Next Page
Loading...
