Kikusui TOS3200 - Turning the Power Line to the EUT On;Off; Showing;Hiding Communication Errors; Releasing the Protection Status

TOS3200 147
Various Settings
8
Remote Control
Turning the Power Line to the EUT On/Off
OUTP:LINE
Turns the power line to the EUT on/off. You will not be able to start the test if the power line is
on.
Command OUTPut:LINE[:STATe] {ON|OFF|1|0}
OUTPut:LINE[:STATe]?
Parameter Value: ON (1) Power line on
OFF (0) Power line off (default)
Response Returns the power line on/off setting in the <NR1> form.
Showing/Hiding Communication Errors
SYST:CONF:TRAC
Shows or hides the communication error numbers.
Command SYSTem:CONFigure:TRACe {ON|OFF|1|0}
SYSTem:CONFigure:TRACe?
Parameter Value: ON (1) Communication error trace function on
OFF (0) Communication error trace function off (default)
Response Returns the on/off setting of the communication error trace function in the <NR1> form.
Releasing the Protection Status
SYST:PROT:CLE
p. 204
Releases the protection status.
Command SYSTem:PROTection:CLEar
** RCLRCL* RSTRST
See