Kikusui TOS3200 - Clearing the Maximum Measured Value; Voltage, Current, and Power of the EUT

142 TOS3200
Querying the Measured Value
Clearing the Maximum Measured Value
CURR:MAX:CLE
Clears the maximum measured voltage between the reference points and the maximum mea-
sured current that are held. These values are also cleared if you send the *RST or *RCL com-
mand.
Command [SENSe:]CURRent:MAXimum:CLEar
VOLT:MAX:CLE
Clears the maximum measured voltage between A and B that is held. This value is also
cleared if you send the *RST or *RCL command.
Command [SENSe:]VOLTage:MAXimum:CLEar
Voltage, current, and power of the EUT
These queries are valid in all operation modes. If the test is not in progress, make the query
after sending the OUTP:LINE ON command.
READ:CURR:LINE / MEAS:CURR:LINE
Queries the current of the EUT.
Command READ[:SCALar]:CURRent:LINE?
MEASure[:SCALar]:CURRent:LINE?
Response
Returns the current of the EUT in the <NR3> form.
Unit: A
READ:VOLT:LINE / MEAS:VOLT:LINE
Queries the voltage of the EUT.
Command READ[:SCALar]:VOLTage:LINE?
MEASure[:SCALar]:VOLTage:LINE?
Response
Returns the voltage of the EUT in the <NR3> form.
Unit: V