4
TOS3200
The following safety precautions must be observed to avoid
fire hazards, electric shock, accidents, and other failures.
Keep them in mind and make sure to observe them.
Using the product in a manner that is not specified in this man-
ual may impair the protection functions provided by the prod-
uct.
Users
• This product must be used only by qualified personnel who
understand the contents of this operation manual.
• If an unqualified personnel is to use the product, be sure the
product is handled under the supervision of qualified per-
sonnel (those who have electrical knowledge). This is to
prevent the possibility of personal injury.
Purpose of use
• Never use the product for purposes other than the product's
intended use.
• This product is not designed or manufactured for general
home or consumer use.
Input power
• Use the product within the rated input power voltage range.
• For applying power, use the power cable provided. For
details, see the respective page in the operation manual.
• This product is an equipment of IEC Overvoltage Category
II (energy-consuming equipment supplied from the fixed
installation).
Fuse
• The fuse can be replaced on this product. When replacing
the fuse, use a fuse of shape, rating, and characteristics
that conform to the product. For details, see the respective
page in the operation manual.
Cover
• Some parts inside the product may cause physical hazards.
Do not remove the external cover.
Grounding
• This product is an IEC Safety Class I equipment (equipment
with a protective conductor terminal). To prevent electric
shock, be sure to connect the protective conductor terminal
of the product to electrical ground (safety ground).
Installation
• This product is designed for safe indoor use. Be sure to use
the product indoors.
• When installing products, be sure to observe precautions
concerning installation location. For details, see the respec-
tive page in the operation manual.
Relocation
• Turn off the POWER switch, and disconnect the cables
before relocating the product.
• When relocating the product, be sure to include the manual.
Operation
• If a malfunction or abnormality is detected on the product,
stop using it immediately, and remove the power cord plug
from the outlet. Make sure the product is not used until it is
completely repaired.
• Do not disassemble or modify the product. If you need to
modify the product, contact your Kikusui distributor/agent.
Maintenance and inspection
• To prevent electric shock, be sure to unplug the product
before carrying out maintenance or inspection. Do not
remove the external cover.
• Check periodically that there are no tears or breaks in the
power cord and the test lead covering.
• If the panel needs cleaning, gently wipe using a soft cloth
with water-diluted neutral detergent. Do not use volatile
chemicals such as benzene or thinner.
• To maintain the performance and safe operation of the
product, it is recommended that periodic maintenance,
inspection, cleaning, and calibration be performed.
Service
• Kikusui service engineers will perform internal service on
the product. If the product needs adjustment or repairs, con-
tact your Kikusui distributor/agent.
Test leads
• To avoid electric shock, do not touch the tip of a test lead
while testing (during the touch current measurement).
O
p
e
r
a
t
i
o
n
Manual
G
N
L
To Next Page
Loading...
