1-S34
MX5100, WSM
ENGINE
Location of Engine Hooks
1. Remove the original engine hook from the cylinder head rear
end.
2. Install the engine hook (2) using original bolt (M8).
3. Install the engine hook (1) under the turbocharger waste gate
valve.
4. Set the chain sling to the engine hooks as shown in the pictures.
W11513110
Separating Engine from Front Axle Frame
1. Set the disassembling stand to the frame under the battery.
2. Hoist the engine at the engine hooks.
3. Remove the front axle frame mounting screw.
4. Separate the engine from the front axle frame (2).
(When reassembling)
• Lift the front of the axle frame by the gap in the bolt hole, and
tighten the front axle mounting screws.
W10418310
(1) Engine Hook (Front)
(2) Engine Hook (Rear)
(3) Nut (M8)
(4) Bolt (M8)
Tightening torque
Front axle frame mounting
screw (M10)
60.8 to 70.5 N·m
6.2 to 7.2 kgf·m
44.9 to 52.1 lbf·ft
Front axle frame mounting
screw (M12)
102.9 to 117.6 N·m
10.5 to 12.5 kgf·m
76.0 to 86.8 lbf·ft
(1) Front Axle Frame (2) Engine
To Next Page
Loading...
