5-S7
MX5100, WSM
BRAKES
Brake Case
1. Remove the brake case mounting screws and nuts.
2. Separate the brake case, tapping the brake case lever lightly.
(When reassembling)
• Apply grease to the brake ball seats. (Do not grease
excessively.)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the brake case and transmission case, after eliminate the
water, oil and stuck liquid gasket.
• Before installing the brake case to the transmission case, install
the cam plate to the transmission case.
• Place the brake discs (6) so that the hole “A” of brake discs
should be overlapped 50 % or more.
W10139950
Brake Cam and Brake Cam Lever
1. Remove the brake cam mounting nut and remove the brake cam
(2) and brake cam lever (4).
(When reassembling)
• Apply grease to the O-ring (3) and take care not damage the O-
ring.
W10143460
Tightening torque
Brake case mounting stud
bolt
38.2 to 45.1 N·m
3.9 to 4.6 kgf·m
28.2 to 33.3 lbf·ft
Brake case mounting
screw and nut
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 lbf·ft
Brake case lever mounting
screw
62.8 to 72.5 N·m
6.4 to 7.4 kgf·m
46.3 to 53.5 lbf·ft
(1) Brake Case Mounting Screw
(2) Brake Case
(3) Brake Shaft
(4) Steel Ball
(5) Brake Cam plate
(6) Brake Disc
(7) Plate
(1) Brake Case
(2) Brake Cam
(3) O-ring
(4) Brake Cam Lever
To Next Page
Loading...
