LeCroy WaveRunner Xi-A - Operating Environment

WAVERUNNER Xi-A AND MXi-A SERIES
10 WRXi-A-GSM-E Rev A
WARNING TheWARNING signindicatesapotentialhazard.Itcallsattentiontoa
procedure,practiceorconditionwhich,ifnotfollowed,couldpossibly
causebodilyinjuryordeath.IfaWARNINGisindicated,donotproceed
untilitsconditionsarefullyunderstoodandmet.
CATI Installation(Overvoltage)CategoryratingperEN61
010‐1safety
standardandisapplicablefortheoscilloscopefrontpanelmeasuring
terminals.CATIratedterminalsmustonlybeconnectedtosource
circuitswheremeasuresaretakentolimittransientvoltagestoan
appropriatelylowerlevel.
OperatingEnvironment
Theinstrumentisintendedforindoor
useandshouldbeoperatedinaclean,
dryenvironment.Makesurethis
product’soperatingenvironmentiskept
withinthefollowingparameterspriorto
use:
• Temperature:5to40°C
• Humidity:Maximumrelative
humidity80%fortemperaturesup
to31

°Cdecreasinglinearlyto50%
relativehumidityat40

°C.
• Altitude:Upto2,000m

Note:Direct sunlight, radiators, and other
heat sources should be taken into account
when assessing the ambient temperature.
WARNING
Theoscilloscopemustnotbeoperatedin
explosive,dusty,orwet/damp
atmospheres.
Thedesignoftheinstrumenthasbeen
verifiedtoconformtotheEN61010‐1
safetystandardperthefollowinglimits:

• Installation(Overvoltage)
• CategoriesII(MainsSupply
Connector)&I(Measuring
Terminals)
• PollutionDegree2
• ProtectionClassI


CAUTION
Protecttheoscilloscope’sdisplaytouch
screenfromexcessiveimpactswith
foreignobjects.
CAUTION
Donotexceedthemaximumspecified
frontpanelterminal(CH1,CH2,CH3,CH4,
EXT)voltagelevels.RefertoSpecifications
formoredetails.
