LeCroy WaveRunner Xi-A - Page 60

GETTING STARTED MANUAL
WRXi-A-GSM-E Rev A 59
ThismathoperationisdifferentfromtheHistogrammathoperationandisnot
affectedbyCenterandWidthsettingsmadethere.
PERSISTENCEHISTOGRAMSETUP
1. TouchMathÆMathSetuponthemenubar.
2. TouchoneoffunctiontabsF1throughFxThenumberofmathtraces
availabledependsonthesoftwareoptionsloadedonyouroscilloscope.
3. TouchinsidetheSource1fieldandselectasourcefromthepop‐upmenu.
4. Touchinsidethe
Operator1fieldand
selectPhistogramfrom
theSelectMathOperator
menu.
5. Totherightofthetrace
dialog,touchthe
Phistogramtab,then
touchinsidetheSlice
Directionfieldandselect
HorizontalorVertical
slicefromthepop‐up
menu.
6. TouchinsidetheSlice
Centerfieldandentera
value,usingthepop ‐up
keypad.

7. TouchinsidetheSliceWidthfieldanden
teravalue,usingthepop‐up
keypad.YoucanalsousetheClearSweepsandCenterCursorbuttonsfor
convenience.
Note:YoucanusethefrontpanelAdjustknobsintheCursorsgrouptomovethe
SliceCenterlineandtheSliceWidthboundarylines.