Viva Series, Coordinate Systems 153
8.3 Coordinate Systems - Creating and Editing
)
Coordinate systems can be defined by manual creation or determined by calculation.
In this chapter, the manual creation of coordinate systems is explained. Refer to "39 Deter-
mine Coordinate System" for information on the determination by calculation.
)
Coordinate systems with a Classic 3D transformation can be defined by manual creation.
)
The type of transformation of the selected coordinate system determines which elements
of a coordinate system can be edited. The name of the coordinate system, the method of
residual distribution and the geoid model in use are always editable.
)
For coordinate systems with source RTCM, only the geoid model in use can be changed.
However, if no projection is received with the automatic coordinate system, then the projec-
tion can also be defined.
Access In Coordinate Systems, highlight a coordinate system. A copy of this coordinate system is
taken for further configurations. Press New.. or Edit...
To Next Page
