Viva Series, Configuration of Devices 449
20.1.5 Radios for Remote Control
Typical uses • To remote control the TPS.
• To transmit data between a TPS and computer.
Supported radios • The default radios used with TPS for remote control are the internal radio RadioHandle
and the external radio TCPS28. The TPS has to be set to the correct communication mode
to send and receive data and commands via the radio. A radio is also integrated in the
field controller to allow communication.
• A Communication side cover must be fitted to the TPS when operating with the Radio-
Handle.
User defined radios Other radios than the default radios can be used. Their settings must be defined by creating
a new radio configuration. Refer to "20.3 Creating/Editing a Device". These radios must be
connected with a cable. Refer to "Appendix E Cables" for information on cables.
To Next Page
