Viva Series, Instrument - Instrument status info 487
Next step
Page changes to the RTK base page.
Raw Data Logging
Status,
RTK base page
As shown below, the name of the page changes depending on the type of base used.
Logging data
from more than
5 sats since
The time for how long five or more satellites are tracked on L1 and L2
without interruption. If less than five satellites were tracked, the counter
is reset. The counter is not reset after Meas, Stop or Store.
Measurement
completed
The percentage of collected data required for successful processing. It is
a conservative estimate based on a 10 - 15 km baseline. The criteria used
to display this value depend on the settings for Automatically stop point
measurement, Stop criteria and Enter the values to be used to automat-
ically stop the point occupation: in Main Menu: Instrument\GPS
settings\Quality control.
Time to go The estimated time in hours, minutes and seconds until the configured
criteria for Stop criteria or Enter the values to be used to automatically
stop the point occupation: is reached. The criteria used to display this
value depend on the settings for Automatically stop point measurement,
Stop criteria and Enter the values to be used to automatically stop the
point occupation: in Main Menu: Instrument\GPS settings\Quality
control.
Field Description
Name of page Description
RTK base Base is a real base station.
Base (Nearest) Base is the closest to the rover determined by for example Leica GNSS
Spider.
To Next Page
