Cleaning synchronization and
Remote alarm System (CRS+)
Chapter 4 - page 14
M-HE.002.1003
4.5.7 Interaction with milk tank control
You can activate the dairy milk collection procedure by pressing the hotkey "Emptying the milk tank" (figure 4.7)
(for additional information, please refer to section 4.6.1 ’Hotkeys’).
Depending on the type of milking system, the function of this hotkey is adjustable to ensure that the same key is
used consistently (see menu option below).
You can skip emptying of the milk delivery line through the setting "Blow milk l. at tank driver pr.", by selecting
"yes" or "no" (figure 4.21).
Wait HUBBLE Waiting for release of HUBBLE (currently not used)
Start oper. Start putting ASTRONAUT milking robots into operation
Wait in op. Waiting for ASTRONAUT milking robots being put into operation
End clean. End of cleaning
Fin. clean. Finishing of cleaning
Table 4.2 Synchronizing of main cleaning
Display text Description
Figure 4.7 Hotkey "Emptying the milk tank"
Alarm system →
Cleaning system →
Settings →
Tests →
Event history →
Alarm system settings →
Cleaning system settings →
General settings →
Postcool time for pre-cooler → 30 sec. (0 - 90 sec.)
Milk tank configuration → (1 t auto)
Blow milk l. at tank driver pr. → (yes/no)
Twin filter present → (yes/no)
Delay time exchange milk filter →
Wizard configuration outputs →
To Next Page
Loading...
