Safety decals
Page xiv
M-WE.001.0705
Safety decals
Safety decal maintenance:
Safety decals located on the ASTRONAUT milking robot contain important and useful information that will help
you operate your machine/equipment safely.
To assure that all decals remain in place and in good condition, follow these instructions:
• Keep safety decals clean and legible at all times.Use soap and water - not mineral spirits, abrasive cleaners,
or other similar cleaners that will damage the decal.
• Replace safety decals that are missing or have become illegible.
• Replaced parts that displayed a safety sign must also display the current decal.
• Safety decals can be purchased from your local Lely service provider.
How to install safety decals:
• Be sure that the installation area is clean and dry.
• Ensure that the temperature of the mounting surface is at least 5°C (40°F).
• Decide on the exact position before you remove the backing paper.
• Remove the smallest portion of the split backing paper.
• Align the decal over the specified area and carefully press the small portion with the exposed sticky backing
in place.
• Slowly peel back the remaining paper and carefully smooth the remaining portion of the decal in place.
• Small air pockets can be pierced with a pin and smoothed out using the piece of decal backing paper.
SAFETY DECAL MESSAGES AND LOCATIONS
General safety messages appear in this safety messages section. Specific safety messages are located in
appropriate sections of the manual where a potential hazard may occur if the instructions or procedures are not
followed.
The safety decal locations on the equipment are shown in the illustrations that follow.
REMEMBER - If safety decals have been damaged, removed, become illegible or parts replaced without safety
decals, new safety decals must be applied. New safety decals are available from your nearest Lely service
provider.
To Next Page
Loading...
Need help?
General
