Lenze i410 - Reset Parameters to Default

11.2 Reset parameters to default
With the "Load default sengs" device command, all parameters can be reset to the default
seng.
By
execung this device command, all parameter sengs made by the user are
lost!
The currently used sengs are reset by the Lenze sengs (delivery status). If no storage is
executed, the parameters saved on the SD card will not be changed.
Parameter
Address Name / seng range / [default seng] Informaon
0x2022:001
(P700.01)
Device commands: Load default sengs
(Device commands: Load def. se.)
•
Seng can only be changed if the inverter is
disabled.
1 = reset all parameters in the RAM memory of the inverter to the
de
fault seng that is stored in the inverter rmware.
•
All par
ameter changes made by the user are lost during this process!
•
It may take some seconds to execute the task. When the task has
been executed successfully, the value 0 is shown.
•
Loading parameters has a direct eect on the cyclic communicaon:
The data exchange for control is interrupted and a communicaon
error is generated.
0 O / ready Only status feedback
1 On / start Execute device command
2 In progress Only status feedback
3 Acon cancelled
4 No access
5 No access (Inverter disabled)
Device
funcons
Reset parameters to default
220