Lenze i410 - Parameter Change-Over

12.2 Parameter change-over
For up to 32 freely selectable parameters, this
funcon provides a change-over between four
sets with dierent parameter values.
DANGER!
Changed parameter sengs can become
eecve immediately depending on the acvang
method set in 0x4046 (P755.00).
The possible consequence is an unexpected response of the motor sha while the inverter is
enabled.
▶
If possible, only carry out parameter changes while the inverter is disabled.
▶
Certain device commands or sengs which might cause a crical state of the drive
behaviour can generally only be carried out when the inverter is inhibited.
Details
The parameter list is compiled in the same way as that of the "Favorites" via
conguraon. »EASY Starter« provides a user-friendly parameterisaon dialog for this
purpose.
Change-over to another value set can oponally be
eected via corresponding device
commands and/or special funcons/triggers:
4De
vice commands for parameter change-over^ 234
4Funcons for parameter change-over^ 236
Addional
funcons
Parameter change-over
231