Lenze i410 - Setpoint Diagnostics

7.7 Setpoint diagnoscs
The following parameters show the current setpoints of dierent setpoint sources.
Parameter
Address Name / seng range / [default seng] Informaon
0x282B:007 Inverter diagnoscs: Default frequency setpoint
•
R
ead only: x.x Hz
•
From version 03.00
Display of the frequency setpoint of the standard setpoint source set in
0x2860:001 (P201.01).
0x282B:008 Inverter diagnoscs: Preset frequency setpoint
•
Read only: x.x Hz
•
From version 03.00
Display of the preset frequency setpoint selected via the four funcons
"Acvate preset (bit 0)" ... " Acvate preset (bit 3)".
4Setpoint presets^ 69
0x282B:009 Inverter diagnoscs: Actual frequency setpoint
•
R
ead only: x.x Hz
•
From version 03.00
Display of the currently selected frequency setpoint that is internally
transferred to the motor control.
0x282B:010 Inverter diagnoscs: Default PID setpoint
•
Read only: x.xx PID unit
•
From version 03.00
Display of the PID control value of the standard setpoint source set in
0x2860:002 (P201.02).
0x282B:011 Inverter diagnoscs: Preset PID setpoint
•
Read only: x.xx PID unit
•
From version 03.00
Display of the preset PID setpoint selected via the four funcons
"Acvate preset (bit 0)" ... " Acvate preset (bit 3)".
4Setpoint presets^ 69
Conguring the frequency control
Se
tpoint diagnoscs
128