EasyManua.ls Logo

Lenze i410 - 15 Technical Data; Standards and Operating Conditions; Conformities;Approvals; Protection of Persons and Device Protection

Lenze i410
334 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15 Technical data
15.1
Standards and operang condions
15.1.1 Conformies/approvals
Conformity
CE
2014/35/EU Low-Voltage Direcve
2014/30/EU EMC Direcve (reference: CE-typical drive system)
EAC
TR CU 004/2011 Eurasian conformity: safety of low voltage equipment
TR CU 020/2011
Eurasian conformity: electromagnec compability of technical
means
RoHS 2011/65/EU
Restricons on the use of certain hazardous substances in
electrical and electronic devices
Approval
UL UL 61800-5-1
for USA and Canada (requirements of the CSA 22.2 No. 274)
File No. E132659
15.1.2 Protecon of persons and device protecon
Degree of protecon
IP20 EN 60529
Data applies for operaonally ready mounted state and not in wire
r
ange of terminals
UL 50 Protecon against accidental contact only
Open type Only in UL-approved systems
Insulaon resistance
Overvoltage category III EN 61800-5-1 0 … 2000 m amsl
Overvoltage category II EN 61800-5-1 over 2000 m amsl
Isolaon of control circuits
Safe mains isolaon via double/reinforced
insulaon
EN 61800-5-1
Leakage current
> 3.5 mA AC, > 10 mA DC EN 61800-5-1 Please observe regulaons and safety instrucons!
Starng current
≤ 3 x rated mains current
Protecve measures against
Short circuit
Earth fault Earth-fault protected depending on operang status
Overtemperature of motor I²xt monitoring
Overvoltage
Motor stalling
15.1.3 EMC data
Noise emission
Category C2 EN 61800-3 See rated data
Category C3 EN 61800-3 See rated data
Noise immunity
Fullls requirements according to EN 61800-3
Operaon on public supply systems
Take measures to limit the expected radio
in
terference:
The machine or system manufacturer is responsible for
compliance with the requirements for the machine/system!
< 1 kW: With mains choke
EN 61000-3-2
> 1 kW for mains current ≤ 16 A: Without
addional measures
Mains current > 16 A: with mains choke or
mains lter, with dimensioning for rated
power.
EN 61000-3-12
Technical data
EMC da
ta
308

Table of Contents

Other manuals for Lenze i410

Related product manuals