Lenze i410 - Configure Digital Outputs; Relay Output

10.3 Congure digital outputs
10.3.1
Relay output
Sengs for the relay.
Relay only switches if the inverter is supplied with 240 V or 400 V.
Use a c
orresponding suppressor circuit in case of an inducve or capacive
load!
Details
The relay is controlled with the trigger selected in 0x2634:001
(P420.01).
The following sengs are possible for the relay:
•
Inversion
①
•
Switch-on delay
②
•
Cutout delay
③
COM
NC
NO
0x4018:0050x4018:006
1
0
1
0x2635 001: 0x4018 004: 0x4018:003
0x2634:001
X9
0x4018:007
Trigger
Diagnosc parameters:
•
The logic s
tatus of the trigger signal is displayed in 0x4018:006.
•
The logic status of the relay is displayed in 0x4018:005.
•
The current switching cycles of the relay are shown in 0x4018:007.
Parameter
Address Name / seng range / [default seng] Informaon
0x2634:001
(P420.01)
Digital outputs funcon: Relay
(Dig.out.funcon: Relay
funcon)
Assignment of a trigger to the relay.
Trigger = FALSE: X9/NO-COM open and NC-COM closed.
Trigger = TRUE: X9/NO-COM closed and NC-COM open.
Notes:
•
An inversion set in 0x2635:001 (P421.01)is taken into consideraon
here.
0 Not connected No trigger assigned (trigger is constantly FALSE).
1 Constant TRUE Trigger is constantly TRUE.
11 Digital input 1 State of X3/DI1, taking an inversion set in 0x2632:001 (P411.01) into
consideraon.
12 Digital input 2 State of X3/DI2, taking an inversion set in 0x2632:002 (P411.02) into
consideraon.
13 Digital input 3 State of X3/DI3, taking an inversion set in 0x2632:003 (P411.03) into
consideraon.
14 Digital input 4 State of X3/DI4, taking an inversion set in 0x2632:004 (P411.04) into
consideraon.
15 Digital input 5 State of X3/DI5, taking an inversion set in 0x2632:005 (P411.05) into
consideraon.
50 Running TRUE if inverter and start are enabled and output frequency > 0 Hz.
Otherwise FALSE.
Excepon, quick stop mode: TRUE if inverter and start are enabled and
output frequency > 0.2 Hz. Otherwise FALSE.
51 Ready for operaon TRUE if inverter is ready for operaon (no error acve, no STO acve and
DC-bus voltage ok). Otherwise FALSE.
TRUE, wenn Inverter betriebsbereit (kein Fehler akv und
Zwischenkreisspannung ok). Sonst FALSE.
52 Operaon enabled TRUE if inverter and start are enabled. Otherwise FALSE.
53 Stop acve TRUE if inverter is enabled and motor is not started and output
frequency = 0.
I/O extensions and control connecons
Congure digital outputs
R
elay output
211