Lenze i410 - Save Parameter Settings with Keypad

Changing inverter sengs by means of the keypad (general operaon)
AUTO SET
REM
0 0 0 O 1 5
AUTO SETREM
AUTO SETREM
O P 4 O O x x
AUTO SETREM
AUTO SETREM
O P 4 2 O x x
AUTO SETREM
O P 4 2 O O 1
AUTO SETREM
O P 4 2 O O 2
1
AUTO SETREM
VEL:FLEX:AIN1
0 0 0 S T O P
G R O U P O O G R O U P O 4
2. Apply change
Change
to
parameterisation mode
Back to the operating mode
Back
Back
Operating mode
Release brake
SUB parameter level
DO1 functionRelay function
Discard change
1. Change settings
Editing mode
Parameter level
Group level
Dig.out.function
I/O setting
Function list
Favorites
13.1.2.3 Save parameter sengs with keypad
If one parameter seng has been changed with the keypad but has not been saved in the
memor
y module with mains failure protecon, the SET display is blinking.
In order to save parameter sengs in the user memory of the memory module, press and
hold the enter key for longer than 3 s.
MAN MAN MANAUTO AUTO AUTOLOC LOC LOCREM REM REM
VEL Saving Parameters Parameters S aved :FLEX:AIN1
SET SET SET
> 3 s
0 0 0 S T O P S A V I N G P S P
S
A
V
E D
Using accessories
K
eypad
Keypad parameterisaon mode
250