Lenze i410 - Keypad Parameterisation Mode; Parameter Groups

13.1.2 Keypad parameterisaon mode
In the
parameterisaon mode of the keypad you can have actual values of the inverter
displayed for purposes of diagnoscs and change sengs of the inverter.
Use the
to change from operang mode to the parameterisaon mode.
•
If a writ
e access protecon is acve for the inverter, the keypad automacally displays a
log-in when changing t
o the parameterisaon mode. You can either skip the log-in and
thus keep the access protecon acve or remove it temporarily by entering a valid PIN.
•
Use the
to return to the operang mode.
13.1.2.1 Parameter groups
In order to provide for quick access, all parameters of the inverter are divided into dierent
groups according to their funcon.
•
Gr
oup 0 contains the congurable "Favorites". In the default seng these are the most
c
ommon parameters for the soluon of typical applicaons. 4Favorites ^ 24
•
Based on the hundreds digit of the display code (Pxxx) you can quickly see in which group
the parameter is to be found on the keypad:
Parameter Group/name Descripon
P1xx Group 1 - Diagnoscs Diagnosc/display parameters for displaying device-internal process factors, current
actual v
alues, and status messages.
4
Diagnosc parameters ^ 273
P2xx Group 2 - Basic seng Seng of the mains voltage, selecon of the control and setpoint source, start and stop
behavior, frequency limits and ramp mes.
4Basic
seng ^ 30
P3xx Group 3 - Motor control Conguraon of the motor and motor control
4
Conguring the motor control ^ 140
P4xx Group 4 - I/O seng Funcon assignment and conguraon of the inputs and outputs
4Start, stop and rotang
direcon commands ^ 43
4
Congure digital inputs ^ 203
4Congure analog inputs ^ 205
4Congure digital outputs ^ 211
4Congure analog outputs ^ 216
P5xx Group 5 - Network seng Conguraon of the network (if available)
P6xx Group 6 - Process controller Conguraon of the process controller
4
Conguring the process controller ^ 98
P7xx Group 7 - Addional funcons Parameterisable addional funcons
4
Addional funcons ^ 228
P8xx Group 8 - Sequencer The "sequencer" funcon serves to dene a programmed sequence of speed setpoints,
PID setpoints or torque setpoints for the motor control. Switching to the next setpoint
can be executed in a me-based or event-based manner.
4Sequencer ^ 73
Using accessories
K
eypad
Keypad parameterisaon mode
248