Lenze i410 - Function of Keypad Keys in Operating Mode

13.1.1.2 Funcon of keypad keys in operang mode
In the
operang mode, the keypad can be used for local control and for manual setpoint
selecon.
Funcon of keypad keys in operang mode
Key Actuaon Condion Acon
Briey Local keypad control acve.
Display "LOC"
Run motor.
Remote control
acve
Display "REM"
Display "KSTOP"
Deacvate keypad triggered stop.
The motor remains at standsll.
Display changes from "KSTOP" to "STOP".
Briey No Jog
operaon Stop motor.
Display "KSTOP"
Briey Operang mode Change to parameterisaon mode.
4K
eypad parameterisaon mode ^ 248
Longer than 3 s None (anyme possible) Save parameter sengs in the user memory of the memory
module.
Briey During operaon Scroll through informaon in the above status line.
Briey Manual setpoint selecon via keypad
acve.
Display "MAN"
Change frequency setpoint.
CTRL
Briey Operang mode Acvate full keypad control
Displa
y "ON?" à Conrm with
Control and setpoint selecon can now only be carried out via
k
eypad.
Renewed clicking: Exit full keypad control.
Display "OFF?" à Conrm with
4Keypad full control ^ 47
R
F
Briey Local keypad control acve.
Display "LOC"
Reversal of rotaon direcon.
Display "REV?" à Conrm with
4
Congure R/F and CTRL keys ^ 266
Example: Change setpoint
If the setpoints are selected manually via keypad, the frequency setpoint can be changed in
the
operang mode via the arrow keys (even while the motor is running):
MAN AUTO SETLOC REM
VEL:KPD:KPD
0 0 0 S T O P
MAN AUTO SETLOC REM
P202.01 Hz
0 0 0 O 2 O O
MAN AUTO SETLOC REM
P202.01 Hz
0 0 0 O 3 5 6
Change settings
Editing mode is automatically quit after 3 s of inactivity
Editing modeOperating mode
Using accessories
K
eypad
Keypad operang mode
246