Lenze i410 - Select Motor from Motor Catalog

5.7.1 Select motor from motor catalog
The following describes how to parameterise your drive system by selecng a Lenze motor
fr
om the motor catalogue. Several processes are started invisibly in the background to load/
calculate the sengs for the relevant parameters.
Precondions
•
Access t
o a Lenze engineering tool (e. g. »EASY Starter«).
•
Parameters can be set online or
oine (with or without connected motor).
Required steps
1.Open the Lenze engineering tool that provides for the funconality of a “Motor Catalog".
2.Click the Select motor... buon. In case of the »EASY Starter«, you nd the Select motor...
buon on the "sengs". tab.
3.Select the motor used in the "Select motor" dialog:
By entering lter criteria, you can restrict the selecon.
Name (e. g. "MCS..."), rated power and C86 value can be found on the motor
nameplate.
Observe the notes on the ?
buon.
4.Click the OK
buon to start the opmizaon.
Parameterizaon sequence
As soon as the parameterizaon has been started, the following steps are iniated by the
engineering tool:
1.The motor rang data and the motor equivalent circuit diagram data are loaded from the
motor catalog.
2.The motor controller sengs and the speed controller sengs are automacally calculated
based on the previously loaded data.
Notes:
•
The data involved in this parameterizaon are provided by the motor catalog alone.
Further user data is not required.
•
The inverter characteriscs are not changed by this opmizaon.
Basic
seng
Motor data
Select motor from motor catalog
40