Lenze i410 - Page 267

Address Name / seng range / [default seng] Informaon
0x2602:003
(P708.03)
Manual control: Mode
(Manual c
ontrol: Mode)
•
From version 03.00
Acvate/deacvate full keypad control.
•
This seng can be changed directly via the keypad key
CTRL
if the
k
ey in 0x2602:001 (P708.01) has not been disabled.
•
When the control mode is changed over, the motor is stopped and the
"Forward" direcon of rotaon is set.
0 Keypad full control o
1 Keypad full control on
2 Manual mode
•
Access via engineering t
ools only.
•
The
acve control is removed from the current control source /
setpoint source.
•
Start and stop command as well as the setpoint are controlled via a
special dialog.
•
A connecon control is acve (engineering tool <-> inverter)
•
The operator is responsible for the safety and impact of this funcon.
Using accessories
K
eypad
Keypad sengs
267