Lenze i950 - Page 143

Address Designaon Default seng Seng range
0x5051:031 Speed control adapon min. value 20.00 % 0.00 ... 100.00 %
0x5051:032 Speed controller actual gain x.xx % (Read only)
0x5051:033 Eecve set speed x.xx rev/s (Read only)
0x5051:064 Eecve velocity for diameter
calculaon x.xxxx mm/s (Read only)
0x5051:069 Source of line velocity for diameter calculaon 0
0x5051:096 Actual diameter x.xxxx mm (Read only)
0x5051:110 Actual moment of inera - (Read only)
0x5051:124 Acceleraon compensaon set torque x.xx Nm (Read only)
0x5052:174 Source of dancer control inuence External [0] Selecon list
0x5052:175 Set dancer control inuence 0.00 % -21474836.48 ... 21474836.47 %
0x5052:176 Eecve dancer control inuence x.xx % (Read only)
0x5052:177 Source of dancer set posion External [0] Selecon list
0x5052:178 Dancer set posion 0.00 % -21474836.48 ... 21474836.47 %
0x5052:187 Eecve dancer control set posion x.xx % (Read only)
0x5052:188 Filter me dancer posion 0.005 s 0.001 ... 0.010 s
0x5052:189 Eecve actual dancer posion x.xx % (Read only)
0x5052:190 Dancer posion raw value - (Read only)
0x5052:192 Dancer control output actual value x.xxxx mm/s (Read only)
0x5052:200 Stored material length in dancer 0.0000 mm -214748.3648 ... 214748.3647 mm
0x5052:201 Filter me dancer movement 0.005 s 0.001 ... 0.010 s
Conguring the "Winder Dancer" TA
Signal ow
143