Lexmark MS81 Series - Duplex Exit Diverter Removal

• “Media vertical guide removal” on page 296
•
“MPF feeder lift plate removal” on page 298
• “MPF pick roller removal” on page 301
• “MPF tray removal” on page 303
•
“Right inner cover removal” on page 304
• “Sensor (input) removal” on page 305
•
“Sensor (toner density) removal” on page 307
• “Transfer roller left arm with cable removal” on page 308
• “Transfer roller right arm removal” on page 309
•
“Transfer roller removal” on page 312
Duplex exit diverter removal
1 Remove the left cover. See “Left cover removal” on page 273.
2 Remove the controller board access shield. See “Controller board access shield removal” on page 342.
3 Remove the media tray. See “Media tray removal” on page 332.
4 Remove the MPF tray. See “MPF tray removal” on page 303.
5 Remove the front door. See “Front door removal” on page 284.
6 Remove the toner cartridge.
7 Remove the imaging unit.
8 Remove the MPF feeder lift plate. See “MPF feeder lift plate removal” on page 298.
9 Remove the media turn guide. See “Media turn guide removal” on page 295.
10 Remove the media vertical guide. See “Media vertical guide removal” on page 296.
4063
Repair information
282