Lexmark MS81 Series - Toner Rubs off; Paper Jams

Toner rubs off
Actions Yes No
Step 1
Check if the fuser screws are tightly fastened.
Are they tightly fastened?
Go to step 2. Reseat the fuser, and
tighten the screws.
Step 2
Check the following fuser components for wear or damage:
• Gears
• Exit rollers
• Heat belt or hot roller
Are they free of damage?
Go to step 3. Replace the fuser. See
“Fuser removal” on
page 316.
Step 3
Check the cables on the LVPS.
Are the connections on the above component properly connected?
Contact the next level
of support.
Replace the LVPS. See
“LVPS removal” on
page 357.
Paper jams
•
“Understanding jam numbers and locations” on page 47
• “200–201 paper jams” on page 49
• “Sensor (input) static jam service check” on page 53
•
“Sensor (input) early arriving jam service check” on page 53
• “Sensor (input) never‑ or late‑arriving jam service check” on page 54
•
“Sensor (input) late-leaving or did-not-clear jam service check” on page 56
• “Main drive motor control jam service check” on page 57
• “Printhead motor control jam service check” on page 58
•
“Fuser drive motor control jam service check” on page 58
• “Sensor (input) miscellaneous jam 1 service check” on page 58
• “Sensor (input) miscellaneous jam 2 service check” on page 59
•
“Sensor (input) miscellaneous jam 3 service check” on page 59
• “202 paper jams” on page 60
• “Sensor (fuser exit) static jam service check” on page 62
•
“Sensor (fuser exit) late-leaving jam service check” on page 62
4063
Diagnostic information
46