Lexmark MS81 Series - Fuser Unit Smart Chip Service Check; Printer Hardware Errors (100-199.99)

Fuser unit smart chip service check
Action Yes No
Step 1
Ensure that the fuser is installed properly.
Is the fuser properly installed?
Go to step 2. Reinstall the fuser
properly.
Step 2
Remove the fuser and install a different fuser.
Does the error remain?
Go to step 3. Problem resolved.
Step 3
Ensure the cable for socket "J27" on the controller board is properly
connected.
Is the above component properly connected?
Go to step 4. Reseat the connection
or replace the cable.
Go to step 4.
Step 4
Reset the machine.
Does the error continue?
Replace the controller
board. Go to
“Controller board
removal” on page
340
.
Problem resolved.
Printer hardware errors (100-199.99)
• “Printer hardware error messages(100‑199.99)” on page 100
•
“Printhead ID service check” on page 104
• “Printhead service check” on page 104
• “Fuser drive motor service check” on page 105
•
“Fuser service check” on page 105
• “LVPS service check” on page 106
•
“Toner level sensing service check” on page 106
• “Main drive motor service check” on page 107
• “Media feeder service check” on page 107
•
“Redrive motor service check” on page 108
• “Duplex motor service check” on page 108
• “Toner add motor service check” on page 109
•
“Main cooling fan service check” on page 109
• “Cartridge cooling fan service check” on page 110
• “LVPS cooling fan service check” on page 110
•
“HVPS cooling fan service check” on page 111
• “Miscellaneous cooling fan service check” on page 111
4063
Diagnostic information
99