3 Close the rear door.
4 To clear the message and continue printing, select Next > > Clear the jam, press OK > .
200.xx paper jams
Error code Description Action
202.01 Media remains on the sensor (narrow media)
during the warm‑up sequence (MS71x)
See “Sensor (narrow media) static jam service check” on
page 65.
202.01 Media remains on the sensor (fuser exit)
during the warm‑up sequence
See “Sensor (fuser exit) static jam service check” on page 62
.
202.03 The media is late reaching the sensor (fuser
exit) within the specified time
See
“Sensor (fuser exit) late-arriving jam service check” on
page 63.
202.05 The media reached the sensor (fuser exit) but
did not clear it within the specified time
See “Sensor (fuser exit) late-leaving jam service check” on
page 62.
202.07 The media reached the sensor (fuser exit) but
did not clear it within the specified time
See “Sensor (fuser exit) late-leaving jam service check” on
page 62.
202.13 The media is late reaching the sensor (fuser
exit) within the specified time
See “Sensor (fuser exit) late-arriving jam service check” on
page 63.
202.14 Expected banner sheet (assumed wide) not
detected by narrow media sensor—possible
accordion jam, unsupported narrow banner
media, or missing signal
See “Sensor (narrow media) late arriving jam service check” on
page 64.
202.16 Page at fuser nip before fuser started
ramping
toward
desired area. Indicates code
may be receiving more hall interrupts than
intended
See
“Fuser drive motor control jam service check” on page 58.
202.17 Page at fuser nip before fuser reached
acceptable operating temperature. Page
arrived at fuser earlier than expected, so it
was probably staged
See “Fuser drive motor control jam service check” on page 58.
202.22 Cartridge Motor—Motor under‑speed error.
Motor made it to closed loop at a steady
state, but then detected speed was below
threshold
See “Fuser drive motor control jam service check” on page 58.
202.28 The sensor (fuser exit) rebounded upon being
released by the trailing edge of the media
See “Sensor (fuser exit) miscellaneous jam service check” on
page 66.
202.31 Media remains on the sensor (narrow media)
during the warm‑up sequence
See “Sensor (narrow media) static jam service check” on
page 65.
202.32 The media reached the sensor (fuser exit) but
did not clear it within the specified time
See “Sensor (fuser exit) late-leaving jam service check” on
page 62.
202.33 Expected wide page not detected by sensor
(narrow media), possible accordion jam or
missing signal
See “Sensor (narrow media) late arriving jam service check” on
page 64.
202.43 The media is late reaching the sensor (fuser
exit) within the specified time
See “Sensor (fuser exit) late-arriving jam service check” on
page 63.
4063
Diagnostic information
61
To Next Page
Loading...
