LSIS S100 User Manual

106
Learning Basic Features
• Note that the motor can overheat or be damaged if excessive amount of DC braking is applied to
the motor, or DC braking time is set too long.
• DC braking is configured based on the motor’s rated current. To prevent overheating or damaging
motors, do not set the current value higher than the inverter’s rated current.
4.17.3 Free Run Stop
When the Operation command is off, the inverter output turns off, and the load stops due to
residual inertia.
Group
Code
Name
LCD Display
Parameter Setting
Setting Range
Unit
ADV 08 Stop Method Stop Mode 2 Free-Run 0–4 -
Note that when there is high inertia on the output side and the motor is operating at high speed, the
load’s inertia will cause the motor to continue rotating even if the inverter output is blocked.

LSIS S100 Specifications

General

Brand	LSIS
Model	S100
Category	DC Drives
Language	English