LSIS S100 - Local;Remote Mode Switching

84
Learning Basic Features
4.6 Local/Remote Mode Switching
Local/remote switching is useful for checking the operation of an inverter or to perform an
inspection while retaining all parameter values. Also, in an emergency, it can also be used to
override control and operate the system manually using the keypad.
The [ESC] key is a programmable key that can be configured to carry out multiple functions.
Group
Code
Name
LCD Display
Parameter Setting
Setting Range
Unit
DRV
90
[ESC] key functions
-
2
Local/Remote
0–2
-
06
Command source
Cmd
Source*
1 Fx/Rx-1 0–5 -
Local/Remote Mode Switching Setting Details
Code
Description
DRV-90
[ESC] key functions
Set DRV-90 to 2(Local/Remote) to perform local/remote switching using the [ESC]
key. Once the value is set, the inverter will automatically begin operating in
remote mode. Changing from local to remote will not alter any previously
configured parameter values and the operation of the inverter will not change.
Press the [ESC] key to switch the operation mode back to “local.” The SET light will
flash, and the inverter will operate using the [RUN] key on the keypad. Press the
[ESC] key again to switch the operation mode back to “remote.” The SET light will
turn off and the inverter will operate according to the previous drv code
configuration.