Learning to Perform Basic Operations
3.4 Parameter Initialization
The following example demonstrates how to revert all the parameter settings back to the factory
default (Parameter Initialization). Parameter initialization may be performed for separate groups in
Parameter mode as well.
• Monitor mode is displayed.
• Press the [MODE] key to move to the Config (CNF) mode.
• Press the [▼] key to go to CNF-40 (Parameter Init).
• Press the [PROG/ENT] key.
• In the list of options, select All Groups, and then press the
[PROG/ENT] key.
• The parameter initialization option is displayed again when
the initialization is complete.
To Next Page
Loading...
Need help?
General
