LSIS S100 - Page 121

109
Learning Basic Features
Frequency Limit Using Upper and Lower Limit Frequencies - Setting Details
Code
Description
ADV-24 Freq Limit
The initial setting is 0 (No). Changing the setting to 1 (Yes) allows the setting of
frequencies between the lower limit frequency (ADV-25) and the upper limit
frequency (ADV-26). When the setting is 0 (No), codes ADV-25 and ADV-26 are
not visible.
ADV-25 Freq Limit
Lo,
ADV-26 Freq Limit Hi
Set an upper limit frequency to all speed unit parameters that are expressed in
Hz or rpm, except for the base frequency (DRV-18). Frequency cannot be set
higher than the upper limit frequency.