BAS(Basic function group) ................................................. 160
basic configuration diagram ............................................... 12
Basic group ....... Refer to BAS (Basic function group)
basic operation .............................................................................. 37
bit 112
bit (Off ) ......................................................................................... 113
bit (On) .......................................................................................... 113
bit setting .................................................................................... 113
multi-function input setting ............................................. 112
Bootlace Ferrule ............................................................................ 26
brake resistor ................................................................................... 20
braking resistors ............................................................................ 12
broadcast ......................................................................................... 134
built-in communication ...........................Refer to RS-485
BX 232
Ｃ
cable ....................................................................... 8, 17, 18, 19, 22
Ground Specifications ............................................................... 8
Power I/O Cable Specifications ............................................ 8
selection.................................................... 8, 17, 18, 19, 22, 276
shielded twisted pair ...............................................................34
signal(control) cable specifications .................................... 9
cable tie ............................................................................................... 27
carrier frequency ........................................................................... 21
derating ........................................................................................ 260
charge indicator .................................................... 16, 231, 237
charge lamp ..................................................................................... 16
cleaning ............................................................................................ 241
CM terminal ............................................................................ 24, 27
CNF (configuration mode) .................................................... 43
COM(communication function group)..................... 190
command ........................................................................................... 81
configuration ...............................................................................81
Command source ........................................................................ 81
fwd/rev command terminal ................................................81
keypad .............................................................................................81
RS-485 ..............................................................................................83
run command/rotational direction configuration ..82
common terminal .......................... Refer to EG terminal
communication ........................................................................... 125
command loss protective operation ........................... 129
communication address ..................................................... 138
communication line connection.................................... 126
communication parameters............................................. 127
communication speed ........................................................ 127
communication standards ................................................ 125
memory map ............................................................................ 131
PLC .................................................................................................. 125
protocol ........................................................................................ 133
saving parameters defined by communication .... 131
setting virtual multi-function input .............................. 130
Communication function group........... Refer to COM
(communication function group)
compatible common area parameter ....................... 142
CON (Control Function group) ...................................... 171
Control group .......... Refer to CON (Control Function
group)
control terminal board wiring ............................................ 22
cooling fan
fan replacement ...................................................................... 245
cursor keys ........................................................................................ 38
[DOWN] key ..................................................................................38
[LEFT] key .......................................................................................38
[RIGHT] key ....................................................................................38
[UP] key ...........................................................................................38
Ｄ
DC braking
DC braking after start ........................................................... 103
DC braking after stop ........................................................... 105
DC braking frequency .......................................................... 105
delta wiring ........................................................................... 29, 248
digital source ................................................................................... 85
display ................................................................................................... 39
display mode table ...................................................................43
display modes .............................................................................42
disposal ................................................................................. 241, 246
Drive group............... 155, Refer to DRV (Drive group)
To Next Page
Loading...
Need help?
General
